System Settings
3-29
2
Press [S] or [T] to select Auto Clear
Time Setting and press [Change #].
3
Use [+] to increase or [-] to decrease the
auto clear timeout from 10 to 270
seconds.
4
Press [Close]. The touch panel will return to the Machine Default screen.
Selecting Output Destination
You can specify the default destination for finished copies.
NOTE: This menu is available when the copier is equipped with the optional document finisher.
1
Access the Machine Default screen. (For instructions, refer to Accessing the Machine Default
Screen on page 3-20.)
2
Press [S] or [T] to select Select Copy
output mode and press [Change #].
System Menu
Machine De fault
Default menu
Special paper action mode
Original Orientation
Sleep mode changing time
Change #
Low power mode chng. time
Au to Cl e ar Tim e Setting
System Menu / Counter
Setting mode
Top Edge Top
Minute
Seconds
Minute
Adjust print direction
1515
90
90
Au to Cl e ar Ti m e Se tti ng Back
System Menu
Set the period of time from the last operation, afte r
wh i ch the de faul t state i s reve rted.
Machine Defaul t
Seconds
-
90
Destination Description
Auto Copies are sent to the empty tray. If multiple trays are empty,
copies are sent to the bottom tray first and higher trays thereafter.
Tray A Tray A of the document finisher.
Tray B Tray B of the document finisher. This tray is not available if the
multi-job tray is installed.
Tray 1 Tray 1 (the first tray) of the multi-job tray.
Tray 2 Tray 2 (the second tray) of the multi-job tray.
Tray 3 Tray 3 (the third tray) of the multi-job tray.
Tray 4 Tray 4 (the fourth tray) of the multi-job tray.
Tray 5 Tray 5 (the fifth tray) of the multi-job tray.
System Menu
Machine De fault
Default menu
Original Orientation
Sleep mode changing time
Low power mode chng. time
Change #
Au to Cl e ar Tim e Setting
Se l ect Co py o utp ut tray
System Menu / Counter
Setting mode
Top Edge Top
Minute
Seconds
Minute
Tray A
15
90
90
To Next Page
Loading...
