Copying Functions
1-69
Processing of Finished Copies
Specify stacking of accomplished copies as follows. If your copier is equipped with the optional
document finisher, you can also specify stapling or hole punching.
1
On the [Basic] screen, press [Finished].
NOTE: The finishing settings apply to
all other steps. Simply complete this
setting once as an initial step.
2
For finishing, press [On] ([1 set] or
[Output each page]) or [Off]. Refer to
Offset Mode on page 1-10 for details.
For stapling, press [Staple Mode] and
complete the settings. Refer to Stapling
on page 1-11 for details.
Function Optional Equipment Description
Stacking Document finisher: None Each completed set is rotated 90° before
stacking.
Document finisher: Installed Stacked by the document finisher.
Stapling Document finisher: None Stapling is not available.
Document finisher: Installed Stapling is available.
Center margin
stapling
Document finisher: None Center margin stapling is not available.
Document finisher: Installed
Folding unit: None
Center margin stapling is available.
Document finisher: Installed
Folding unit: Installed
Center margin stapling as well as center
margin with center folding is available.
Punching Document finisher: None Punching not is available.
Document finisher: Installed
Punching unit: Installed
Punching is available.
Pl ace ori g i nal s th e n pre ss S tart ke y.
BackStaple Mode
Ready to Job build.
Top Edge
Select Original
Orientation.
Limited number of staple pages.
Off
1 staple
2 staples
The limit is set in setting mode.
When selecting staple function
the offset can not be combined.
Staple
Top
!
To Next Page
Loading...
