Kyocera TASKalfa 620 - Using Programs to Copy; Editing Program Names

Copying Functions
1-58
Using Programs to Copy
Follow the steps as below to copy using registered programs.
1
Press [Program].
2
Press the program number (1 to 8) to
recall the program.
3
Place the originals in the document processor or on the platen and press the Start key to copy using
the program as it was created.
Editing Program Names
Follow the steps as below to rename programs.
1
Press [Program].
2
Press [Change Name].
3
Press the number (1 to 8) of the program
to rename.
4
Enter the new program name and press
[End] to register the program with the
new name.
NOTE: For instructions on entering
characters, refer to Entering
Characters on Touch Panel on
page 3-55.
Ready to copy.
11x8
Paper Size
Reg./D el ete
Register
Delete
Change
ProgramFu n cti onUser choiceBasic
Recall
100%
Nam e
to copy.
11x8½"
Paper Size Set
Reg./D elete
Register
Delete
Change
4 in 1
Sheet
Margin
Le ft
ProgramFun cti o nUser cho i ce
100%
Nam e
Bord Erase
Registration name change
Select the number for changing name.
No registrati o n
Nam e to d i sp l ay
Capital
Stop
Lette r Num ./ S ym. Space
Char.Limit:16 including #
AllDel.