Copying Functions
1-40
Continuous Scan
Scans multiple originals for a single copy job without using the document processor. You can also
prepare single copy jobs if there are too many originals to place at once when using the document
processor. Divide the original into smaller sets and scan each set with the document processor. In
Continuous Scan mode, you can continue scanning originals until you press [Scanning finished].
Follow the steps as below to use Continuous Scan.
1
Press [Function].
2
Press [Continuous Scan].
3
Press [On].
4
Place the originals in the document processor or on the platen and press the Start key.
Place the next original and press the Start key. Repeat these steps to scan the remaining originals.
After scanning all originals, press [Scanning finished] to start copying.
To Next Page
Loading...
