Kyocera TASKalfa 620 - Density Level

Copying Functions
1-71
Original Orientation
Specify the original orientation as follows.
1
On the [Basic] screen, press [Original
Orient.].
Based on the original orientation, press
[Top Edge Top] or [Top Edge Left].
NOTE: Failure to place originals
correctly may result in copying errors.
2
Press [Close].
Density Level
Specify the copy density level as follows.
1
Press [Quality]. On the next screen,
press [Density].
2
For automatic density adjustment, press
[Auto]. To adjust the density manually,
press [Manual]. Next, press [Lighter] or
[Darker] to adjust the density.
3
Press [Close].
Ready to Job build.
Job Build
11x8½"
Paper
1 sided
Basic
Quality
Zoom
Top Edge Top
Original
Fi n i sh i ng
2 sided Copy
Edit
1 sided copy-Left
Fi n i sh e d page #:
Step
Auto %
Original
P l ace ori g i nal s th e n p re ss S tart ke y.
Orient.
1 sided/
2 sidedSelection
Type
nals the n pre ss S tart key.
Set
Back
Top Edge
Select Original
Orientation.
Top Edge
Closetatio n
to Job build.
Check Original Orientation. can
be shown at right side of display.
Follow the steps. If setting mode is
wrong, incorrect copy will result.
Le ft
Top
Ready to Job build.
Job Build
Density 4
Density
Text + Photo
Basic
Quality
Off
Edit
1 sided copy-Left
Fi n i sh e d page #:
Step
Original
P l ace ori g i nal s th e n p re ss S tart ke y.
EcoPrint
Im ag e
Pl ace ori g i nal s th e n pre ss S tart ke y.
BackDensity
Ready to Job build.
Auto
Manual
Li ghte r D arke r