Copying Functions
1-41
Proof Mode
Delivers a single copy of a high-volume copy job to check before approving the job. If there are any
problems with the copy, simply cancel the job to avoid wasting paper.
Follow the steps as below to check a single copy in a job.
1
Press [Function] and then [T Down].
2
Press [Proof Copy] ([Test Copy]).
3
Press [On].
4
Place the originals in the document processor or on the platen. Press the Start key to deliver a test
copy.
5
After delivering the test copy, the
confirmation screen will be displayed.
The copier will remain in standby mode
until the job is approved or cancelled.
Check the test copy.
If it is acceptable, press the Start key to
deliver the specified quantity.
To change the copy quantity, press
[Change Preset].
If there is a problem with the copy, press [Cancel] to redo the copy settings.
To Next Page
Loading...
