Copying Functions
1-34
3
Press [Booklet].
4
Specify the binding direction of both the
originals and finished copies.
If the message It is impossible to copy in
present setting mode. Change setting of
original and finishing mode is displayed,
confirm that you are selecting the correct
original orientation (shown at the right of
the touch panel) and the proper settings
for the original and finished copies.
5
If the copier is equipped with the optional document finisher, [Saddle Stitch] ([Center Staple]) will be
displayed and you can specify center margin stapling. If the copier is also equipped with a folding
unit, you can specify folding along the center of copies where the center margin is stapled. To
specify center margin stapling or a center margin with center folding, press [Saddle Stitch] ([Center
Staple]) and follow these steps.
To skip these settings, move to step 7.
6
Select [Saddle stitch] or [Bind & Fold]
and press [Close]. Up to 16 sheets
(64 pages) can be created with center
margin stapling or with center margin
stapling and center folding.
7
To set up a cover, press [Stitching Front Cvr] ([Stitching Front cov.]) and move to the next step.
To skip the cover settings, move to step 9.
8
Press [Cover] and specify whether or not
to copy on the front and back covers.
Press [Close].
9
Place the originals in the document processor or on the platen and press the Start key.
NOTE: When using the platen, be sure to place the originals in page order.
If the original is placed on the platen, Scan next original(s) will be displayed. Place the next original
and press the Start key.
After scanning all originals, press [Scanning finished] to start copying.
To Next Page
Loading...
