Kyocera TASKalfa 620 - Page 69

Copying Functions
1-63
Complete the Settings Common to All Steps
Specify Duplexing and Repeat Copy.
NOTE: Repeat Copy is used to enable additional copies later.
A variety of other settings and functions are available besides those shown in this example. Refer to
Specifying Copy Functions on page 1-67 for details.
2
Press [1 sided/2 sided]
([1-sided/2-sided]).
3
Press [2 sided Copy] ([2-sided Copy])
and [Binding Left]. Press [Close] to
return to the screen of step 2.
4
Press [Edit]. On the next screen, press
[Repeat Copy].
5
Press [On]. Press [Close] to return to the
screen of step 4.
Pl ace o ri g i nal s th e n p re ss Start ke y.
Job Build
Ready to Job build.
11x8½"
Paper
1 sided
Original
Basic
Quality
Zoom
Top Edge Top
Fi n i shi n g
1 sided/
2 sided
Original
Orient.
1 sided Copy
Edit
1 sided copy-Left
Fi n i she d p ag e #:
Step
Auto %
Selection Type
Pl ace o ri g i nal s th en p re s s S tart ke y.
Back
Select Original
1 sided
2 sided
Orientation.
Top Edge
1 sided/2 sided Copy
Ready to Job build.
Fi n i sh i n g
Binding
Binding
Binding
Copy
Copy
Le ft
Right
Top Top
Pl ace ori g i nal s th e n pre ss S tart ke y.
Job Build
Ready to Job build.
Off
Border
Auto
Basic Quality
Page #
Tray A
Repeat
OutputMargin/
Centering
Off
Edit
2 sided copy-Left
Fi n i sh e d page #:
Step
OffOff
Original
SizeErase Copy
Tray
Pl ace ori g i nal s th e n pre ss S tart ke y.
BackRe pe at Cop y
Ready to Job build.
When select [O n], j o b can b e save
Yo u can re cal l and re-p ri n t at an yt
You can set a password to secure
document.
Off
On