90 X75HD/X75SD Installation and Operation Manual
Chapter 5: Initial Configuration
5. Scroll to the Subnet Mask parameter, and then press Enter.
If this is a new unit being configured, the default subnet mask
displays. Otherwise, the current subnet displays.
6. Repeat the procedure described in step 4, this time for the subnet
mask.
7. Scroll to the Gateway parameter, and then press Enter.
If this is a new unit being configured, the default gateway displays.
Otherwise, the current gateway address displays.
8. Repeat the procedure described in step 4, this time for the gateway
parameter.
9. Select Save IP, and then press Enter.
10. Select Ye s option and then press Enter.
11. Press Exit to return to the Setup menu.
12. Navigate to the Setup menu, select Reboot, and then press Enter.
To restart an X75HD/SD unit with a blank front panel, unplug it
and then reapply power.
Setting the IP Addresses of Multiple Units
If you have multiple X75HD/X75SD systems that require network
configuration, you will need to set unique IP addresses and assign a
subnet mask and gateway address for each of them one at a time. The
following procedure summarizes the required steps:
1. Apply power to the first X75HD/X75SD unit with a frame-mounted
local control panel.
When ready for configuration, the main X75HD/X75SD menu
shows on the display screen.
2. Configure the network settings for this unit, as described in the
procedure on page 89.
3. Restart the X75HD/X75SD unit.
4. Plug in the next X75HD/X75SD system, configure its network
information, and then restart the unit.
Follow this procedure for all remaining X75HD/X75SD units that
require configuration.
5. If you will be using a remote panel, configure the RCP’s network
settings in the same way as you would for an X75HD system (see
page 95).
To Next Page
