X75HD/X75SD Installation and Operation Manual 91
Chapter 5: Initial Configuration
6. Connect all X75HD/X75SD systems and remote panels to a
network hub or switch using a 10/100Base-T Ethernet cable.
7. Ensure that all configured X75HD/X75SD units are detected on the
network.
To do this, press Remote on the front panel of either an RCP or a
frame-mounted local control panel. All units configured with the
same subnet mask address will display (you will see a list of all
detected IP addresses).
If a unit or RCP is not detected, ensure that the subnet mask address
is accurate. Alternatively, confirm that all units were restarted after
configuring any network settings.
Note
If configured to be on the same
network, the following items
will be detected:
X75HD/X75SD systems,
X75-RCP panels, and any
DPS-575 systems.
To Next Page
