Lenze L-force 9400 Series - Page 358

9400 regenerative power supply module | Parameter setting
Index
358 L EDS94ARNExxxx EN 2.3 - 06/2014
Status word
Digital inputs (C02803)
338
Digital outputs (C02802) 338
Status word device control 1 (C00150) 284
Status word device control 2 (C00155) 284
Status/Control word ECTRL (C00156) 285
Store parameters (I-1010) 151
SYNC cycle time (C01121) 324
Sync phase position 118
Sync phase position (C01122) 325
Sync source (C01120) 324
Sync telegram 115
Sync tolerance (C01123) 325
Synchronisation of PDOs 115
Sync-PLL increment (C01124) 326
System fault messages 198
System task
Task overflow (error message)
243
System task 1
Task overflow (error message)
243
System task 2
Task overflow (error message)
243
System task 3
Task overflow (error message)
243
T
Task runtimes 53
Technology application 21
Temperature inside the controller (C00062) 277
Therm. capacity brake resistor (C00131) 281
Time 328, 329
Time error - controller interface (error message) 225
Time stamp of sampled max. power (C00144) 283
Touch probe x
Delay time (C02810)
338
TPDO1 communication parameter (I-1800) 165
TPDO1 mapping parameter (I-1A00) 168
TPDO2 communication parameter (I-1801) 166
TPDO2 mapping parameter (I-1A01) 168
TPDO3 communication parameter (I-1802) 167
TPDO3 mapping parameter (I-1A02) 169
TPDO4 communication parameter (I-1803) 167
TPDO4 mapping parameter (I-1A03) 169
U
User code
Memory load (C02110)
332
UserTask
Overflow (error message)
218
V
Violation of time slice (error message) 225
W
Warning thres. brake resistor (C00572) 314
Warning thres. brake transistor (C00570) 313
Warning threshold device util. (C00123) 280