FLIR Client 12 for PC / Mac
13
1. Click Remote Setting in the top-right corner of the window.
2. Under Settings, click Network, then click the Email tab.
3. Select Enable from the dropdown next to Email to enable email notifications using a
custom mail server.
4. Use the dropdown next to Encryption to select an encryption type.
5. Click the field next to SMTP Port to enter the SMTP port.
6. Click the field next to SMTP Server to enter the URL used by your mail server.
7. Click the field next to User Name to enter your user name for the mail server.
8. Click the field next to Password to enter your password for the mail server.
9. Click the field next to Sender Email to enter the sending email address. This can be
any email of your choice.
10. Click to enter up to 3 email addresses that will receive email notifications from the
system.
11. Use the dropdown next to Interval to set the minimum amount of time between email
notifications. This can be used to limit the number of notifications you receive through-
out the day.
12. Click Save.
Email notifications are now enabled. The default schedule is set to send email notifica-
tion whenever motion is detected or a system warning occurs. To configure the sched-
ule for email notifications, see 13.6.13 Setting an Email Schedule, page 108.
13.6.13 Setting an Email Schedule
The email schedule determines the time periods that the system will send out email notifi-
cations. You can set separate schedules for motion events and system warnings per
channel.
Prerequisites:
• You must enable email notifications for the email schedule to take effect. To enable
email notifications, see 13.6.12 Setting up Email Notifications, page 107.
To set an email schedule:
#LX400086; r. 1.0/39246/39246; en-US
108
To Next Page
Loading...
Need help?
General