LSIS LSLV-S100 - Page 207

Learning Advanced Features
193
Group
Code
Name
LCD Display
Parameter Setting
Setting Range
Unit
04 Analog output1 filter AO1 Filter 5
0–10000
ms
05 Analog constant output1 AO1 Const % 0.0
0.0–100.0
%
06 Analog output1 monitor AO1 Monitor 0.0
0.0–1000.0
%
Voltage and Current Analog Output Setting Details
Code
Description
OU.01 AO1 Mode
Select a constant value for output. The following example for output voltage
setting.
Setting
Function
0
Frequency
Outputs operation frequency as a standard. 10V
output is made from the frequency set at dr.20(Max
Freq)
1
Output
Current
10V output is made from 200% of inverter rated
current (heavy load).
2
Output
Voltage
Sets the outputs based on the inverter output
voltage. 10V output is made from a set voltage in
bA.15 (Rated V).
If 0V is set in bA.15, 200V/400V models output 10V
based on the actual input voltages ( 240V and 480V
respectively).
3
DC Link Volt
Outputs inverter DC link voltage as a standard.
Outputs 10V when the DC link voltage is 410Vdc for
200V models, and 820Vdc for 400V models.
4
Torque
Outputs the generated torque as a standard.
Outputs 10V at 250% of motor rated torque.
5
Ouput Power
Monitors output wattage. 200% of rated output is
the maximum display voltage (10V).
6
Idse
Outputs the maximum voltage at 200% of no load
current.
7
Iqse
Outputs the maximum voltage at 250% of rated
torque current
  
=
�
 
2
−   
2
8
Target Freq
Outputs set frequency as a standard. Outputs 10V
at the maximum frequency (dr.20).
9
Ramp Freq
Outputs frequency calculated with Acc/Dec
function as a standard. May vary with actual output
frequency. Outputs 10V.
12
PID Ref Value
Outputs command value of a PID controller as a
standard. Outputs approximately 6.6V at 100%.