LSIS LSLV-S100 - Page 218

204
Learning Advanced Features
Code
Description
Codes CNF-20–23 share the same setting options as listed in the table
below.
Setting
Function
0
Frequency
On stop, displays the set frequency. During
operation, displays the actual output
frequency (Hz).
1
Speed
On stop, displays the set speed (rpm). During
operation, displays the actual operating speed
(rpm).
2
Output Current
Displays output current.
3
Output Voltage
Displays output voltage.
4
Output Power
Displays output power.
5
WHour
Counter
Displays inverter power consumption.
6
DCLink Voltage
Displays DC link voltage within the inverter.
7
DI Status
Displays input terminal status of the terminal
block. Starting from the right, displays P1–P8.
8
DO Status
Displays output terminal status of the terminal
block. Starting from the right, Relay1, Relay2,
and Q1.
9
V1 Monitor[V]
Displays the input voltage value at terminal V1
(V).
10
V1 Monitor[%]
Displays input voltage terminal V1 value as a
percentage. If -10V, 0V, +10V is measured,
-100%, 0%, 100% will be displayed.
13
V2 Monitor[V]
Displays input voltage terminal V2 value (V).
14
V2 Monitor[%]
Displays input voltage terminal V2 value as a
percentage.
15
I2 Monitor[mA]
Displays input current terminal I2 value (A).
16
I2 Monitor[%]
Displays input current terminal I2 value as a
percentage.
17
PID Output
Displays output of PID controller.
18
PID Ref Value
Displays reference value of PID controller.
19
PID Fdb Value
Displays feedback volume of PID controller.
20
Torque
If the torque reference command mode (DRV-
08) is set to a value other than keypad (0 or 1),
the torque reference value is displayed.
21
Torque Limit
If torque limit setting (Cn.53) is set to a value
other than keypad (0 or 1), the torque limit
value is displayed.
23
Spd Limit
If the speed limit setting (Cn.62) on torque
control mode is set to a value other than
keypad (0 or 1), the speed limit setting is
displayed.