Learning Advanced Features
Displays the speed of a load in the desired
scale and unit. Displays the speed of a load
that ADV-61 (Load Spd Gain) and ADV-62
(Load Spd Scale) are applied as rpm or mpm
set at ADV-63 (Load Spd Unit).
CNF-21–23 Monitor Line-x
Select the items to be displayed in monitor mode. Monitor mode is the
first displayed mode when the inverter is powered on. A total of three
items, from monitor line-1 to monitor line- 3, can be displayed
CNF-24 Mon Mode Init
Selecting 1(Yes) initializes CNF-20–23.
Load Speed Display Setting
Group Code Name LCD Display Parameter Setting
Unit
ADV(M2)
61(40)
Rotation count speed gain
Load Spd Gain - 100.0 1~6000.0[%] -
62(41)
Rotation count speed scale Load Spd Scale 0 x 1 0~4 Hz
63(42)
Rotation count speed unit Load Spd Unit 2 rpm 0~1 A
Load Speed Display Setting Detail
Code Description
ADV-61(M2-40)
Load Spd Gain
If monitoring item 24 Load Speed is selected and if the motor spindle and
the load are connected with belt, the actual number of revolutions can be
displayed by calculating the pulley ratio.
ADV-62(M2-41)
Load Spd Scale
Selects the decimal places that monitoring item 24 Load Speed displays
(from x1–x0.0001).
ADV-63(M2-42)
Load Spd Unit
Selects the unit of monitoring item 24 Load Speed. Selects between RPM
(Revolution Per Minute) and MPM (Meter Per Minute) for the unit.
For example, if line speed is 300 [mpm] at 800 [rpm], set ADV61 (Load Spd
Gain) to "37.5%" to display the line speed. Also, set ADV62 (Load Sped Scale)
to "X 0.1" to display the value to the first decimal point. And set ADV63 (Load
Spd Unit) to mpm. Now, the monitoring item 24 Load Speed is displayed on
the keypad display as 300.0 mpm instead of 800 rpm.
Inverter power consumption
Values are calculated using voltage and current. Electric power is calculated every second and the
results are accumulated. Setting CNF-62 (WH Count Reset) value to 1(Yes) will reset cumulated electric
energy consumption. Power consumption is displayed as shown below:
To Next Page
Loading...
