Step 1 Front Cover, Control Terminal Cover and Cable Guide
The front cover, control terminal cover and cable guide must be removed to install cables. Refer to
the following procedures to remove the covers and cable guide. The steps to remove these parts
may vary depending on the inverter model.
0.8–1.5kW (single phase), 1.5–
2.2kW (3-phase)
1 Loosen the bolt that secures the front cover (right side). Push and hold the latch on the right
side of the cover. Then remove the cover by lifting it from the bottom and moving it away
from the front of the inverter.
2 Remove the bolt that secures the front cover (left side) (❶). Push and hold the latch on the
left side of the cover. Then remove the cover by lifting it from the bottom and moving it away
from the front of the inverter (❷).
To Next Page
Loading...
