Lucent Technologies MERLIN LEGEND Release 6.1 User Manual

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Issue 1
August 1998
Features
Page 139Centrex Operation
Feature Interactions 3
Authorization Code In Release 6.0 and later Key or Hybrid/PBX mode systems, forwarding
features, including Centrex Transfer via Remote Call Forwarding but
excluding Follow Me, can be activated or deactivated at an extension on
the system by entering the authorization code for the extension on the
same system from which calls are to be forwarded. The user enters the
authorization code, then activates or deactivates the feature in the normal
fashion. This is especially useful for a single-line telephone user who
must include a Pause character in a Remote Call Forwarding dialing
sequence, because the character cannot be dialed at a single-line
telephone. It is also useful when forwarding options must be changed for
a phantom extension.
Caller ID In Release 3.0 and later systems, companies may use the 800 GS/LS-ID
module to capture calling number identification information (subscribed to
from the central office on loop-start lines only, if available). MLX display
telephones in these systems show the number of an outside call received
on a line connected to the module. However, if the customer also
subscribes to call waiting through Centrex, the number of the waiting call
is not shown on the MLX display.
Calling Restrictions Centrex users should not be assigned calling restrictions because the
calling restrictions should be assigned through the CO.
Conference In Behind Switch mode, the fixed-function Conf button applies to Centrex
operation and is not recognized by the communications system. A button
can be programmed for communications system Conference.
Drop In Behind Switch mode, the fixed-function Drop button applies to Centrex
operation and is not recognized by the communications system. A button
can be programmed for communications system Drop.
Forward and
Follow Me
In Release 6.0 and later systems, using the limited Centrex configuration,
outside calls may be remote call-forwarded on the same analog Centrex
loop-start line on which they arrived.
Forwarding or Remote Call Forwarding can be activated or deactivated by
entering the authorization code for the extension from which calls are to
be forwarded. The user enters the authorization code, then activates the
feature within 15 seconds of entering the authorization code.
Group Calling Calls to calling groups in a system set up in Behind Switch mode follow
the communications system ring pattern, not the central office ring
pattern.
Recall/Timed Flash In Behind Switch mode, a Recall button should be programmed to send
switchhook flash to activate Centrex features. The system supports the
use of a Recall button only on loop-start lines.
SMDR In Release 6.0 and later systems, two SMDR call records can be
generated for Centrex remote call-forwarded calls: one for the incoming
or transferred call to the extension and one for the outgoing call to the
remote telephone number. In order for SMDR to report the calls, the
SMDR minimum call length must be set to zero (0).

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English