MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 584Remote Access
Table 40. Remote Access Routing
Routing Facility User Dials
Facility Remote Access
Programming
Line Loop-start, ground-start,
emulated loop- or
ground-start, BRI, PRI
B-channel group
programmed for line
routing, automatic-in tie,
emulated automatic-in tie
Telephone number Must be programmed for
dedicated or shared remote
access.
Not routed Dial-in tie or emulated
dial-in tie
Remote access
code
Tie default COR settings
Dial-Plan DID or emulated DID,
PRI B-channel group
programmed for dial-plan
routing
Telephone number
including remote
access code
System must be programmed to
add or delete digits to or from
dialed telephone numbers
received, so that the remote
access code is received. Non-
tie default COR settings,
including barrier code
requirement, apply. In networked
Release 6.0 and later systems
particularly, a barrier code
should be required.
Non-local
dial plan
PRI tandem trunk; T1-
emulated tie, T1-emulated
voice tie, or analog tie line
Programmed
extension number
specifying non-
local remote
access code
Default COR settings for tie
and/or non-tie trunks as
applicable, including barrier
code requirement, apply. A
barrier code must be required.
Restrictions are then the ones
associated with each barrier
code and not the ones assigned
to the default COR.
Tandem UDP-routed PRI tandem
trunk; tandem T1-
emulated data tie, T1-
emulated voice tie, or
analog tie line
ARS access code
for remote system
or non-local dial
plan number, plus
telephone number
Remove COR outward
restrictions from tie and/or non-
tie trunks as applicable. Barrier
code required or not required
setting is ignored (should be
required), but Disallowed List is
applied. FRL for default COR
setting is applied to any routing
of the call out of the local system
ARS access code or non-local
dial plan number.
To Next Page
Loading...
Need help?
General
