MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 621Signal/Notify
Signal/Notify 42
At a Glance 42
Description 42
A user can signal another telephone user without making a call to that extension,
using either the Signal feature, which beeps the destination extension, or the
Notify feature, which lights an LED on the destination extension. The meaning of
the signal can be prearranged between the sending and receiving users.
Signal 42
The Signal feature allows a multiline telephone user to beep another telephone.
To use the feature, press a programmed Signal button without lifting the handset.
A beep is heard at the destination extension for as long as the sender holds the
button down.
In addition to sending a beep, the Signal button can be used to see the status of
the destination extension. When the destination user lifts the handset or uses Do
Not Disturb, the green LED next to the Signal button turns on.
A user also can use the Signal button to dial the destination automatically.
However, the user must select an SA or ICOM button and either lift the handset or
press the Speaker button before using the Signal button; this is different from
Auto Dial, which automatically selects a line and activates the speakerphone.
Users Affected Telephone users, operators
Reports Affected Extension information
Modes All
Telephones All except QCC and single-line telephones
Programming Codes
Signal
Notify, Send
Notify, Receive
+
ext. no.
+
ext. no.
+
ext. no.
MLX Display Labels
Signal
Notify, Send
Notify, Receive
6LJQDO>6LJQO@
1RWLI\6HQG>1WI\6HQG@
1RWLI\5HFHLYH>1WI\5HFY@
To Next Page
Loading...
Need help?
General
