MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 567Recall/Timed Flash
Recall/Timed Flash 39
At a Glance 39
Description 39
Recall sends a momentary signal called a
timed flash
or
switchhook flash
while
the phone is on the hook. A timed flash is used as a control signal, as follows:
■ On an inside call, the signal is intercepted by the control unit.
— A multiline telephone user can use Recall to disconnect a call and get a
new dial tone without hanging up. The user can be on an active call or
listening to ringback or dial tone. When the user is listening to a busy
signal, Recall has no effect.
— A single-line telephone user can use Recall to put an active call on hold
and to access system features such as Conference and Transfer.
■ On an outside call, when the system is using host switch services such as
Centrex, the signal may be sent to the host, depending on the type of
telephone and system operating mode.
■ A multiline telephone user can use Recall to access host features. The
user can be connected to another party or can be listening to outside dial
tone, ringback, or a busy signal.
■ A single-line telephone user can use Recall to access host services only if
the system is programmed for Behind Switch mode.
Users Affected Telephone users, DLC operators
Reports Affected Extension Information, System Information (
6\V6HWXS)
Modes All
Telephones All except QCC
Programming Codes
Recall
Conference
Drop
Transfer
(Behind Switch mode only)
(Behind Switch mode only)
(Behind Switch mode only)
Feature Code
MLX Display Label
5HFDOO>5HFOO@
System Programming Change timed-flash duration (recall timer):
●
2SWLRQV→More→5HFDOO7LPHU
Program fixed Conference, Drop, and Transfer buttons to
access host features in Behind Switch mode:
●
2SWLRQV→More→%HKQG6ZLWFK→&RQIHUHQFH'URS
7UDQVIHU
Factory Setting
Recall Timer 450 ms (options 350 ms, 450 ms, 650 ms, 1 sec)
To Next Page
Loading...
Need help?
General
