Lucent Technologies MERLIN LEGEND Release 6.1 User Manual

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Issue 1
August 1998
Features
Page 670System Renumbering
Timed Flash 43
See “Recall/Timed Flash” on page 567.
Integrated
Administration
System renumbering can be done only through system programming on
the programming console or with SPM. Integrated Administration never
sends system numbering information to the system.
Ringing/Idle Line
Preference
In Key and Behind Switch modes, the Idle Line Access code (factory
setting is 9) can be renumbered.
UDP Features In Release 6.0 or later systems (Hybrid/PBX mode only), a separate
numbering plan is provided for non-local dial plan extensions, allowing
system managers to enter the ranges of extensions on remote systems.
These ranges are associated with patterns that in turn allow routing over
private tandem trunks or over PSTN facilities when appropriate. These
ranges must be unique and unambiguous in the local dial plan.
Programming remote extension ranges does not affect the remote system
or the extension numbering used within the remote system. When a
system is renumbered to the factory-set default, non-local dial plan
extension ranges are deleted.
If the dial plan of a remote system in the network changes, the system
administrator must determine the impact on all systems in the private
network. Changes to the non-local dial plan must be made manually at
each system.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English