Lucent Technologies MERLIN LEGEND Release 6.1 User Manual

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Issue 1
August 1998
Features
Page 231Direct Station Selector
Camp-On When Camp-On is used to complete a transfer and the call returns, the
LED of the DSS button associated with the extension transfer destination
stays off and does not flash as it does for a transfer return.
Coverage When an operator transfers an Individual or Group Coverage call and it
returns, the red LED next to the DSS button for the sender does not flash
as it does when a call received on another type of line button returns.
Direct Voice Mail On a QCC’s DSS, the Direct Voice Mail button is a fixed button, the
rightmost button in the second row from the bottom. Direct Voice Mail
functions only for extensions on the same system.
Display When an operator presses a DSS button for a local extension number, the
extension label, if any, and the extension number appear on the display
while it is dialed. If the operator presses a DSS button for a non-local
extension, only the extension number appears.
Do Not Disturb In Release 2.0 and later systems, an operator can use the Inspct button
to check the status of a local extension whose red LED is on. If the user at
the extension is using Do Not Disturb, the Do Not Disturb message is also
posted and appears on the operator’s display. (However, the message
may also mean that the user has posted the message without turning on
the Do Not Disturb feature.)
Extension Status For a local system only, a calling group, CMS supervisor, or an operator at
a DLC with Extension Status assigned can change the status of a group
member or room by pressing a programmed Available or Unavailable
extension status button and then pressing the DSS button for the group
member or room.
Forward and
Follow Me
Activate Forward by pressing a programmed button or using a feature
code, and then pressing a DSS button for the extension where calls
should go. Activate Follow Me by dialing the feature code and then
pressing a DSS button for the sender’s extension number. This activation
of Forward and Follow Me functions only for a local system.
Group Calling In releases prior to 5.0, the DSS button’s LED for a calling group
extension number indicates the status of calls in the calling group queue
on a local system. The LED is on when calls are at or above the
programmed threshold and off when the number is below the threshold.
In Release 5.0 and later systems, a DSS button used as a Calls-in-Queue
Alarm button indicates only two alarm threshold levels instead of the three
that a programmed inside Auto Dial button can display. A DSS either
flashes or lights steadily. The button is unlit when the number of calls in
the queue drops below Threshold 1. The LED lights steadily when the
number of calls in queue is greater than or equal to Threshold 3.
Otherwise, it flashes. If DSS buttons are used to monitor calling group
queue status, only two alarm thresholds should be set. This alarm
functionality works only on a local system.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English