MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 246Directories
Personal Lines A System or Personal Directory can be used to dial numbers on a
personal line. An Extension Directory is used only for inside calls and
cannot be used to dial calls on a personal line.
Pools When a pool dial-out code is included in the telephone number for a
Personal or System Directory listing, a Pause character may be needed
following the pool dial-out code, depending on the local telephone
company. Pause characters are entered by pressing the Hold button.
Recall/Timed Flash Press the Conf button to enter the Flash special character in a Directory
listing telephone number.
Saved Number Dial Saved Number Dial does not store numbers dialed by using a Directory.
Second Dial Tone
Timer
Marked System Speed Dial entries, which do not display, are not affected
by the Second Dial Tone setting. If the central office does not immediately
supply dial tone when a star code is entered and a marked System Speed
Dial entry uses star codes, the appropriate number of pauses (each 1.5
seconds) must be programmed after each star code in the entry.
Speed Dial System Speed Dial numbers are stored in the System Directory. MLX
display telephone users can dial one by selecting the name from the
display. If the number is on a marked System Directory listing, select the
listing; you can dial it despite any calling restrictions (toll or outward)
assigned to your extension.
UDP Features In Release 6.0 and later systems (Hybrid/PBX mode only), non-local
extensions cannot be included in a local Extension Directory. non-local
extensions can be included in Personal and System Directories.
You cannot use a non-local system’s System Directory to make calls.