MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 302Forward and Follow Me
also use Follow Me by pressing the Feature button, selecting the feature from the
display, and dialing the forwarding telephone’s extension.
In Release 6.0 and later systems, you may activate or deactivate Forward or
Remote Call Forwarding from a local system multiline telephone by first entering
your authorization code. When you hear inside dial tone, press the Feature button
and dial
, or dial or , depending on the type of telephone at the
extension you are using.
To turn off Forward, Remote Call Forwarding, and Follow Me at the originating
multiline telephone, press the programmed Forward button, or press the Feature
button and dial
; then dial your own extension number (in effect, “forwarding”
calls to that extension). If you are off hook on an SA or ICOM button, you hear a
confirmation tone, and then dial tone is removed. If a programmed Forward button
is used, the green LED next to the button turns off.
At a destination (receiving) multiline telephone, to cancel Forward and Follow Me
from other local extensions, press the Feature button, dial
, and do one of the
following:
■ To cancel forwarding from one local extension, dial that extension.
■ To cancel forwarding from all local extensions, dial .
NOTE:
Forward from non-local extensions must be cancelled at the extension
forwarding the calls.
If you are off hook on an SA or ICOM button, you hear confirmation tone, and then
dial tone is removed.
Single-Line Telephones
At a single-line telephone, you must connect to an SA or ICOM line to turn on
Forward or Follow Me to an extension or outside line.
To forward to a local extension, lift the handset and then dial
,
followed by the
destination extension number. If you are forwarding to a non-local extension, dial
a pound sign (#) after the non-local extension number. You hear a confirmation
tone, which is a double break in dial tone, and dial tone is removed.
To forward calls to an outside telephone number, lift the handset and dial
.
Then select the outside line/trunk or pool on which to route forwarded calls. Dial
the ARS or pool dial-out code (Hybrid/PBX mode only), the Idle Line Access code
(usually
; Key and Behind Switch modes only), the line/trunk number (usually
801–880), or
for Centrex Transfer via Remote Call Forwarding (Release 6.0 and
later systems). Then dial the destination telephone number followed by a pound
sign (
) to signal the end of the dialing sequence. You hear a confirmation tone,
and dial tone is removed.
To Next Page
Loading...
Need help?
General
