MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 465Park
Multi-Function
Module
A user at an MFM cannot park a call but can pick up a call parked by
another user.
Music On Hold If Music On Hold is programmed, a parked caller hears Music On Hold.
Pickup A parked call can be picked up by using Individual Pickup.
Recall/Timed Flash A single-line telephone user presses a Recall or Flash button to use
Park.
Service Observing In Release 6.1 and later systems, a call that is parked cannot be
observed. Once an extension answers a parked call, the call can be
observed.
SMDR If an incoming call was parked but not picked up by the other extension,
the extension of the user who activated Park is shown in the STN field of
the SMDR record for the call. If an incoming call was parked and picked
up by the destination extension, the destination extension is shown in the
STN field of the SMDR report.
System Access/
Intercom Buttons
When a user parks a call made or received on an SA button, Shared SA
buttons do not ring when the parked call returns.
System
Renumbering
System operator park zones can be renumbered. (The factory-set zones
are 881–888.)
Transfer A user also can park calls by pressing the Transfer button, dialing his or
her own extension, and pressing the Transfer button again. DLC
operators can press Transfer and dial an operator park zone. When this
method is used, complete the transfer by pressing the Transfer button or
by hanging up. This method cannot be used by QCC operators.
UDP Features For Release 6.0 or later systems (Hybrid/PBX mode only), park zones
must be in the local system. Calls cannot be parked at remote system
park zones.
To Next Page
Loading...
Need help?
General
