EasyManuals Logo

Lucent Technologies MERLIN LEGEND Release 6.1 User Manual

Lucent Technologies MERLIN LEGEND Release 6.1
1021 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #517 background imageLoading...
Page #517 background image
MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 468Personal Lines
received on the line/trunk, the caller hears ringback even if that line/trunk does not
terminate anywhere in the system.
When an extension is programmed as the principal user (owner) of a personal
line, only the principal user can forward calls to an outside number by using
Remote Call Forwarding. When the owner has Individual or Group Coverage,
calls received on the personal line follow the owner’s coverage and not the
coverage patterns of other extensions that share the personal line.
When no principal user is assigned for a personal line, calls received on the
personal line cannot be forwarded to outside telephone numbers or to non-local
extensions (Release 6.1 and later systems). Calls follow the Individual Coverage
patterns of all senders who share the line and the Group Coverage pattern of the
extension with the lowest logical identification number (lowest numbered jack on
the module).
Two users can join a call in progress (including a conference call), for up to three
users on the same personal line.
Outside lines/trunks used as personal lines cannot be assigned to pools and
cannot be assigned as jacks for loudspeaker paging, Music On Hold, or
maintenance alarms.
ARS cannot be used on personal lines.
In all modes, personal lines are not factory-assigned to single-line telephones or
tip/ring devices connected to 016 (T/R), 012, or 008 OPT modules.
In Release 2.1 and later systems, calls received on personal lines with Do Not
Disturb on go immediately to coverage instead of waiting for the Coverage Delay
Interval.
Mode Differences 30
Hybrid/PBX Mode 30
When Ringing/Idle Line Preference is turned on and ALS is set to select an SA
button, a single-line telephone user cannot select the personal line to make calls.
However, outside calls can be received on the personal line.
In Hybrid/PBX mode, the factory setting assigns personal lines to DLC positions
rather than to other multiline telephones.
Key and Behind Switch Modes 30
When Ringing/Idle Line Preference is turned on and ALS is set for an ICOM
button, a single-line user can select the personal line to make an outside call by
dialing the Idle Line Access code (usually

) while listening to inside dial tone.

Table of Contents

Other manuals for Lucent Technologies MERLIN LEGEND Release 6.1

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies MERLIN LEGEND Release 6.1 and is the answer not in the manual?

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General IconGeneral
BrandLucent Technologies
ModelMERLIN LEGEND Release 6.1
CategoryConference System
LanguageEnglish

Related product manuals