MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 487Pools
Personal Lines A personal line cannot be assigned to a pool.
Primary Rate Interface
and T1
Data lines (especially T1 data) should not be put in the same pool as
voice lines. System alarms eventually result if voice extensions try to
access data lines.
Recall/Timed Flash If a user presses the Recall button during or after dialing, a timed flash is
sent to the host switch, the accessed line is kept, the user hears dial tone,
and calling restrictions are reapplied.
Service Observing In Release 6.1 and later systems, if an extension uses Dial Access to
make a call, the call can be observed. A call placed or answered on a
Pool button can be observed.
A Service Observer cannot activate Service Observing while off-hook on
a Pool button.
Speed Dial A pool dial-out code can be included with the telephone number
associated with a Personal Speed Dial or System Speed Dial code.
However, depending on the local telephone company, Pause characters
may be required immediately following the pool dial-out code. Enter
Pause characters by pressing the Hold button.
SMDR When outgoing calls are made by using a pool, the line/trunk selected by
the system is reported on the SMDR report.
System
Renumbering
Pool dial-out codes (the factory-set codes are 70 and 890–899) can be
renumbered. Pool dial-out codes can be up to four digits long.
UDP Features All private trunks must be assigned to pools of trunks that are of the same
type (PRI, analog tie, T1-emulated tie voice, or T1-emulated tie data). For
security reasons, dial access and Pool button access to these pools
should not be permitted.
Pool Status buttons show the busy or not-busy status of private trunk
pools as well as outside trunk pools.
When PRI tandem trunks are available, their pools should be assigned as
Route 1 for the purpose of UDP routing.
To Next Page
Loading...
Need help?
General
