MERLIN LEGEND Communications System Release 6.1
Feature Reference
555-661-110
Issue 1
August 1998
Features
Page 510Primary Rate Interface (PRI) and T1
â– In Release 4.2 and later systems, these MCI services are also available:
— MCI PRISM
— MCI Vnet
—MCI 800
—MCI 900
â– In Release 4.2 and later systems, these local exchange carrier services are
also available:
—DMS Private
—DMS INWATS
—DMS OUTWATS
—DMS FX
— DMS Tie Trunk
â– In Release 6.0 and later systems (Hybrid/PBX mode only), where the
Switch Type setting is LEGEND-Ntwk or LEGEND-PBX, the network
service is automatically set to Electronic Tandem Network (ETN) and
cannot be changed unless the Switch Type setting is modified.
Copy Telephone Number to Send 32
This option specifies whether or not the telephone number to send to the network
for outgoing calls made on PRI lines assigned to a B-channel group is copied from
the PRI telephone number assigned to that PRI line. Select the Copy Telephone
Number to Send option when the telephone number sent to the network should
match the number received from the network, indicating the number dialed by the
outside caller. Select the Do Not Copy Telephone Number option either when a
telephone number to send is assigned to each PRI line in the B-channel group or
when no telephone number is to be sent to the network. (This can be used to
block outgoing Caller ID, systemwide.)
NOTE:
In Release 6.0 and later systems (Hybrid/PBX mode only), where the
Switch Type setting is LEGEND-Ntwk or LEGEND-PBX, the Copy
Telephone Number to Send option is set to Copy and cannot be changed
unless the Switch Type setting is modified.
Telephone Number to Send 32
This option assigns the telephone number to send to the network when outgoing
calls are made on PRI lines. If the person being called subscribes to a PRI caller
identification service, the number indicates who is calling.
To Next Page
Loading...
Need help?
General
