Lucent Technologies MERLIN LEGEND Release 6.1 User Manual

MERLIN LEGEND Communications System Release 6.1
Feature Reference 555-661-110
Issue 1
August 1998
Features
Page 45Authorization Code
If you activate the feature while on hook, the feature selects an SA/ICOM button
and turns on the speakerphone, if present.
After you activate the feature, the green LED (if present) next to a programmed
Authorization Code button starts to flash slowly to indicate that you may enter the
code’s digits. An MLX display telephone shows
$XWK, and an analog multiline
display telephone shows
$XWK".
Entering an Authorization Code 0
While you enter the assigned authorization code, you hear inside dial tone. If you
do not enter the code within 15 seconds, the feature is deactivated.
If a telephone with a display is used, the display shows asterisks instead of the
entered digits.
To complete entry of the authorization code, either press a programmed
Authorization Code button again or dial a
 to signify the end of the code. If the
entered authorization code matches an assigned code, you continue to hear
inside dial tone and can start dialing the telephone number.
The green LED associated with a programmed Authorization Code button
becomes steady to indicate that an authorization code has been successfully
entered. The LED remains steady as long as the Authorization Code feature
remains active.
If the authorization code is not valid, you hear an error tone (a high tone followed
by a low tone). The green LED associated with a programmed Authorization Code
button goes off to indicate that the Authorization Code feature is not active. An
MLX display telephone shows the message
$XWK &RGH1RW9DOLG, and an analog
multiline display telephone shows the message
(UURU.
Deactivating an Authorization Code 0
Each entry of an authorization code is good for only one phone call. After
completing a call, the current extension loses home extension privileges. It also
loses privileges for subsequent calls after putting a call on hold or after initiating
Recall, Headset Hang Up, or Park features. If a far-end disconnect is not received
from the central office, you must hang up or select another outside line to
deactivate the Authorization Code feature.
After the feature is deactivated, the green LED next to the Authorization Code
button (if present) turns off.
Considerations and Constraints 0
An authorization code can be entered only while hearing inside dial tone.
Incoming calls are not affected by an authorization code.

Lucent Technologies MERLIN LEGEND Release 6.1 Specifications

General

Brand	Lucent Technologies
Model	MERLIN LEGEND Release 6.1
Category	Conference System
Language	English