Maeda MC405C-3 - Fuse in the Receiver; Removal of the Fuse

Section 4 – REMOTE CONTROL SYSTEM COMPONENTS Mini-Crawler Crane M A E D A
4-98 1/2019 MC405C-3
CAUTION: In the event that the monitor
display (3) indicates an error code, settle the
error as follows:
1. Push the Reset button of the Transmitter.
2. When the practice as above 1. results
another error code, once turn the Receiver
OFF, then start it again.
3. When the practice as above 2. results
further error code, it is suspected that the
Transmitter or Receiver has faults;
contact us or our sales service agency.
For more information on error codes, see
"TROUBLESHOOTING" on page 5-89.
Receptacle
Connect the connection cable from the
Transmitter, here.
Fig. 4-254
CAUTION:
• Before attaching the connection cable to the
receptacle (4), always confirm that the Main
switch (2) is in the OFF position.
After the insertion, secure the plug by the
screw.
• Always apply the water proof cap while the
remote control is not in use.
• In the condition where the remote control is
not provided, this receptacle (4) is
incompetent. Always keep the water proof
cap attached.
Fuse in the Receiver
CAUTION:
• For any tests or replacement of a fuse,
always turn OFF the Main switch of the
Control box, before removing it.
• The fuse must be replaced with the same
type of grass tube fuses, and of the same
rating.
CAUTION: A fuse is inserted in the (+) line of
the main power supply of the Receiver as a
protective circuit of internal devices and
prevents circuits from burnt.
• A grass tube fuse is employed. In the event
where the fuse is corroded and shows white
rust, or when a loose condition is
recognised, always replace it with a new
one.
• When the fuse is blown, never fail to
examine the circuit for the cause and repair
it before replace the fuse.
• The fuse must be replaced with the same
type of grass tube fuses, and of the same
rating.
The fuse is placed inside the Receiver.
Test and replacement of the fuse shall be
practiced as follows:
• Use the following hand tools:
• A screw driver (Philips)
• Jewelers screw driver set (Slotted)
• General hand tools, used to detach the cover of
the control box.
Removal of the Fuse
1. Remove the rear cover as described in
"Removing Rear Cover" on page 5-19.