Section 4 – STOPPING ENGINE Mini-Crawler Crane M A E D A
4-22 1/2019 MC405C-3
STOPPING ENGINE
CAUTION:
• Stopping the engine before it sufficiently
cools down may shorten the life of engine
units. Do not stop the engine suddenly
except for emergency.
• When the engine is overheated, do not stop
the engine suddenly.
Change the engine speed to low speed, and
gradually cool down the engine before
stopping the engine.
• Verify that the main switch at the control
box unit of remote control system is at the
"OFF" position.
1. Release your foot from the acceleration
pedal (6) and change the engine speed to
idling. Continue the no-load operation for
about 5 minutes.
Fig. 4-57
2. Turn the starter switch key to the "OFF"
position.
The engine will stop.
Fig. 4-58
3. Remove the starter switch key.
INSPECTION AFTER
STOPPING ENGINE
1. Visibly check for oil leakage, fuel leakage,
and water leakage, and check around the
crawlers, crane, and exterior of the machine.
If you find any leakage or abnormality, fix the
problem.
2. Top off the fuel tank.
3. Dead leaves and papers around the engine
will cause fire. Remove the dead leaves and
papers.
4. Clean off mud on the crawlers and
outriggers.
To Next Page
Loading...
