Maeda MC405C-3 - Fuses

Section 5 – FUSES Mini-Crawler Crane M A E D A
5-20 1/2019 MC405C-3
FUSES
CAUTION: Be sure to turn the starter switch
to the "OFF" position when checking or
replacing a fuse.
CAUTION: Fuses protect electrical
components and wires from being burnt out.
• Fuses are blade fuses. If a fuse was
corroded and shows white powder, be sure
to change the fuse.
• If a fuse has melt down, always check the
cause in the circuit and repair the problem
before changing the fuse.
• Always use a fuse of the same capacity
when replacing one.
The fuse box is provided at the lower section of
the instrument panel.
Check and replace a fuse using the procedure
below.
1. Remove the buckle (2) of the cover (1) at the
bottom of the instrument panel to open the
cover (1).
Fig. 5-25
2. Remove the cover (3) of the fuse box.
Fig. 5-26
3. Remove the fuse from the fuse box and
check/replace the fuse.
4. Insert a new or checked fuse to the original
position in the fuse box.
[Fuse Capacity and Circuit Names]
Fig. 5-27
The table below shows the fuse system and its
capacity.
Index
Capacity
Circuit Name
A
10 A
Main P.S.
B 10 A PCB
C
10 A
Engine control
D 10 A Solenoid valve
E
10 A
Horn, light
F 20 A
Moment limiter, remote
control system
G 20 A Spare
H
10 A
Spare
I
10 A
Spare