Maeda MC405C-3 - Engine Start and Reset Procedure; Engine Stop and Emergency Stop Procedure

Section 4 – REMOTE CONTROL OPERATION Mini-Crawler Crane M A E D A
4-126 1/2019 MC405C-3
Engine Stop and Emergency Stop
Procedure
WARNING!
• For any abnormalities in crane operations,
push immediately the Stop/EMO button to
stop the engine. Such cases include that the
crane operation does not stop though you
release your fingers from any of the
operation levers or Accelerator lever, or the
Crane starts the operation despite that no
operation lever is manipulated.
• In such event of the emergency stop of the
engine, turn OFF the power of the
Transmitter and check the cause of the
emergency, after the engine stops, and
repair the failure.
• The Stop/EMO button is also available to
stop the engine in the normal conditions.
Push the Stop/EMO button to stop the engine
from the Transmitter or in case of emergency.
The engine stops.
Fig. 4-372
Engine Start and Reset Procedure
Engine Start Procedure
CAUTION: For the practice of the engine start
from the Transmitter Start/Reset button, the
Starter switch of the Crane must be in the ON
position. Otherwise, where the Starter switch
is in OFF position, the engine will not start by
that Start/Reset button.
When it is required to start the engine from the
Transmitter, push the Start/Reset button. The
engine starts.
Fig. 4-373
Reset Procedure
To release the emergency stop equipment or
abnormal signal detector, push the Start/Reset
button.
Power of the Receiver will be reset.
NOTICE:
• While the engine runs, the engine starter will
not work even though the Start/Reset button is
used.
• When the Start/Reset button is used, push the
Power switch of the Transmitter to turn ON it,
beforehand.
• When the Start/Reset button is pushed, the
abnormal signal detector circuit starts working.
Wait for 3 to 4 seconds until it completes.