Maeda MC405C-3 - Periodic Maintenance Procedure; Tension

Section 5 – PERIODIC MAINTENANCE Mini-Crawler Crane M A E D A
5-40 1/2019 MC405C-3
Periodic Maintenance Procedure
Initial 10 Hour Maintenance
The following maintenance should be performed
after 10-hour operation, limited to the first
maintenance of a new machine.
• Greasing Machine Units
See "Grease Machine Units" on page 5-41.
Initial 50 Hour Maintenance
The following maintenance should be performed
after 50-hour operation, limited to the first
maintenance of a new machine.
• Replacement Engine Oil and Oil Filter
See "Replace Engine Oil and Oil Filter" on page
5-46.
• Oil Replacement in Hydraulic Oil Tank
See "Replace Oil in Hydraulic Oil Tank" on page
5-51.
• Replacement Hydraulic Oil Return Filter
See "Replace Hydraulic Oil Return Filter" on
page 5-48.
• Replacement Hydraulic Oil Suction Filter
See "Replace Hydraulic Oil Suction Filter" on
page 5-49.
• Checking / Adjustment Alternator Belt
Tension
See "Check / Adjust Belt Tension" on page 5-44.
Initial 250 Hour Maintenance
The following maintenance should be performed
after 250-hour operation, limited to the first
maintenance of a new machine.
• Oil Replacement Slewing Reduction Gear
Case
See "Replace Oil in Slewing Reduction Gear
Case" on page 5-52.
• Oil Replacement Winch Motor Reduction
Gear Case
See "Replace Oil in Winch Reduction Gear
Case" on page 5-53.
• Oil Replacement Travelling Motor Reduction
Gear Case
See "Replace Oil in Travelling Motor Reduction
Gearcase" on page 5-54.