Section 5 – INSPECTION Mini-Crawler Crane M A E D A
5-26 1/2019 MC405C-3
Check / Add Fuel
DANGER!
• Be extremely careful with fire such as
cigarette.
• Be sure to stop the engine when refuelling.
If refuelling was done with the engine in
operation, the fuel spilled on the section
where it gets hot such as muffler can catch
fire.
• Over-refilling may cause fuel spill. Refuel to
the level slightly lower than the specified
upper limit level. If the fuel spills, be sure to
thoroughly wipe it off.
• Be sure to close the tank cap after
refuelling.
CAUTION:
• For more information on the which oil to be
used, see "LUBRICATING OIL" on page 5-
14.
• Be careful not to let any foreign substance
go into the filler opening when refuelling.
1. Turn the starter switch to the "ON" position.
Fig. 5-35
2. Looking at the fuel gauge on the monitor
panel, check if the fuel is filled to almost full
(around "F").
Fig. 5-36
3. If the fuel level is low, remove the tank cap
(F) on the top of the fuel tank and refuel from
the filler opening while watching the fuel
gauge.
Fig. 5-37
4. After refuelling, turn the tank cap (F) to
securely close it.
NOTICE: Fill the fuel tank to full after finishing the
work for the day.
Check / Clean Water Separator
WARNING!
• The water separator pot has fuel (diesel oil)
inside. Be extremely careful of fire such as
cigarette when cleaning the water separator
pot.
• If the fuel spills when the water separator
pot is removed, thoroughly wipe it off.
CAUTION:
• Water or dust accumulated inside the water
separator pot will cause engine failure.
Check inside the pot and remove any water
or dust accumulated inside.
• If water remains in the water separator pot,
it is assumed that much water is also mixed
in the fuel tank. See "Draining Contaminant
Water/Deposits in Fuel Tank" on page 5-76
and eliminate water and dust mixed into the
fuel tank.
1. Stop the machine at levelled location.
2. Open the access hatch in the right-hand
machinery cover.
To Next Page
Loading...
