Mini-Crawler Crane M A E D A Section 4 – REMOTE CONTROL OPERATION
1/2019 MC405C-3 4-127
Checking After Crane Operation
WARNING!
• When the operation of the Crane is finished,
always turn OFF the Transmitter and
Receiver power.
• In no occasions except the Crane
operations, power of the Transmitter shall
not be turned ON.
That may cause an un-expected motion of
the Crane and result a serious hazard, such
that the Crane hit the other person or any
object, or the Crane tips.
• When it is required to turn ON the
Transmitter for the purpose of inspection or
such, ensure first that the engne is
standstill, then shut down the Receiver by
turning OFF its main switch.
1. Enter into the "CRANE MODE" of the
Transmitter operation mode.
2. Use the operation levers and retract the
boom to its shortest condition and lower it to
the base position, then stow the hook.
3. Enter into the "OUTRIGGER MODE" of the
Transmitter operation mode.
4. Use the operation levers and stow all the
outriggers so that the Crane is configured to
the travelling mode.
5. Stop the engine and turn OFF the
Transmitter power.
6. Shut down the power of the Receiver by
turning its Main switch to the OFF position.
7. Maintain the Transmitter and Receiver as
follows:
(1) Check operation levers and the
Accelerator lever for any faults.
(2) Remove oil or other soil by a clean
cloth, if any.
(3) Repair all the cracks or damages
without fail, if any.
8. Put the Transmitter into the accessory
storage case and keep it in the dry and cool
place where the wind and rain or direct sun
ray is sheltered.
To Next Page
Loading...
