Maeda MC405C-3 - Left;Right Travelling Lever; Level Gauge; Outrigger Un-Set Warning Lamp (Yellow); Travelling Lock Lever

Section 4 – TRAVEL AND CRANE CONTROLS Mini-Crawler Crane M A E D A
4-6 1/2019 MC405C-3
Travelling Lock Lever
Use this lever to "lock" the travelling levers.
Fig. 4-8
• Lock: Push the lever to the right.
• Travel: Push the lever to the left.
NOTICE: Operate the travelling lock lever while
the left and right travelling levers are at the
"Neutral" position.
Left/Right Travelling Lever
Use these levers to move the machine
forward/backward, stop, slew, and to adjust the
travelling speed.
Fig. 4-9
• Forward: Push the left and right levers
forward at the same time.
• Neutral: Release your hands from left and
right levers at the same time. The
levers return to the "Neutral"
position and the machine
automatically brakes and stops at
that position.
• Backward: Pull the left and right levers toward
you at the same time.
• Left turn: Release your hand from the left
lever and operate the right lever
forward or backward.
• Right turn: Release your hand from the right
lever and operate the left lever
forward or backward.
• Spin turn: Operate the left and right levers to
the opposite direction. The left and
right crawlers turn to the opposite
direction, allowing you to make the
spin turn.
Level Gauge
WARNING! When installing the outrigger,
make adjustments while looking at the level
so that the machine body will be levelled.
Performing the crane operation with the body
tilted will cause overturning.
This device indicates how much the machine
body is tilted.
The bubble position shows how much the
machine is tilted in which direction.
Use this device to verify that the machine is
levelled when setting the outriggers.
Fig. 4-10
Outrigger Un-Set Warning Lamp
(Yellow)
The lamp flashes if one of the four outriggers is
not set properly.
Fig. 4-11
NOTICE:
• If the extension or setting of one of the four
outriggers cannot be detected, the outrigger un-
set warning lamp flashes.
• The outrigger un-set warning lamp is linked
with the working status lamp for moment limiter
(red). As the outrigger un-set warning lamp
flashes, the working status lamp (red) also
rotates and lights up.