Maeda MC405C-3 - Remote Control System Specifications

Section 3 – PRINCIPLE SPECIFICATIONS LIST Mini-Crawler Crane M A E D A
3-6 1/2019 MC405C-3
Remote Control System Specifications
System / Item
MCT310
Waterproof protection
IP65
System configuration
Manual and Remote control, both-way
Operation monitor
LCD monitor panel
• Operation status monitor • Battery monitor • Message • Error code
Safety devices
Emergency stop equipment
Abnormal signal detector unit at the engine start
Automatic power cut unit (Automatic Power-OFF)
Voltage drop limiter
Warning switch
Voice messages
(1) Danger, rope over winding
(2) Do not store hook until boom is in travel mode
(3) Remote control is ready
(4) Signal not received
(5) Danger, defective safety device
(6) Danger, defective remote control
(7) Danger, set outriggers
(8) Danger, overload
Control unit voltage
Power for the Crane (DC 12V)
Control unit power consumption
Approximately 70 watts (maximum, per single function)
Operating ambient temperature
-10°C to +55°C
Storage ambient temperature
-20°C to +70°C
Transmitter weight
540g
Transmitter functions
Lever switches
Boom raise/lower
Raising and lowering
Hook raise/lower
Raising and lowering
Boom telescoping
Extending and retracting
Slewing
Counterclockwise (left) / clockwise (right)
Push button switches
Power
ON/OFF
Horn
Warning signal
Hook stow/Setting
Hook stowing/Mode setting
Speed/Mode
Speed control/Mode selection
Start/Reset
Engine start/Reset
Stop/EMO
Engine stop/Emergency stop
Trigger type accelerator
Hydraulic control + Engine control