Mini-Crawler Crane M A E D A Section 4 – REMOTE CONTROL OPERATION
1/2019 MC405C-3 4-125
Setting to the Micro Speed Mode
WARNING! Setting to the Micro speed mode
requires actual crane operations with the
engine running. Before starting the Micro
speed mode setting, always ensure that
nobody except on business is within the
working area.
1. Push the Speed/Mode button several times
so that the LCD screen indicates the
"MICRO SPEED MODE".
Fig. 4-368
2. Push the Hook stow/Setting button for at
least 2 seconds.
Indication of "2" in the LCD screen is high-
lighted and it enters into the "MICRO SPEED
MODE" setting screen.
NOTICE: The "MICRO SPEED MODE" setting is
available while the "2" in the LCD screen is high-
lighted.
Fig. 4-369
3. Push the operation lever to be adjusted and
pull the Accelerator lever slowly.
When the operation speed reaches the
desired maximum speed, push the Hook
stow/Setting button.
Fig. 4-370
NOTICE:
• Perform the same process to other operation
levers, respectively.
• In case that you operate two or more levers at
the same time for this setting, note that the
Micro speed rate is established to the ratio of
the fastest operation of all.
It is recommended that the Micro speed shall
be set one by one of each operation lever
• No operation lever provides the Micro speed
unless otherwise set to the Micro speed mode,
beforehand
4. When the settings for all the required
operation levers are complete push the
Speed/Mode button. Now the setting is
established and the Micro speed mode is
available.
Fig. 4-371
To Next Page
Loading...
