96
[1] Lifting mode
The lifting mode can be switched by touching the screen.
・N : normal mode
・P : power mode
・M : multi-outrigger mode
For the details of each mode refer to “OPERATION – 1.2.1 [4] [10] Lifting mode” section.
[2] Number of falls
The mode can be changed by touching the screen.
•6 : 6 Falls
•4 : 4 Falls
•2 : 2 Falls
•1 : Single Falls
•Searcher Hook (only for machine with searcher hook)
By changing the number of the falls setting, the number of falls display will also change in crane
mode.
The rated total load automatically changes according to the number of falls, so be sure to match
the actual number of falls with the displayed number of falls.
If Searcher Hook is selected, monitor changes to the dedicated screen. Please refer to the
section of “Searcher Hook” in this manual for details.
[3] Language setting
The display language can be changed by touching the screen.
[4] Error history
By touching the screen, the screen transitions to the error history display screen where you can
see the currently occurring errors/errors that have occurred in the past.
For display details of the error, refer to “OPERATION 11.7 LIST OF ERROR CODES” section.
[5] Software version
By touching the screen, the screen transitions to the check screen where the software version
can be checked.
[6] Monitor brightness
By touching the screen, the screen transitions to the brightness control screen where the
brightness can be adjusted.
[7] Time setting
By touching the screen, the screen transitions to the time setting screen where the time can be
changed.
To Next Page
Loading...
