Maeda MC815C - Inspection of Engine Start and Stop Operation (Radio Control); Inspection of Engine Start Operation; Inspection of Engine Stop Operation

285
9.1.5 INSPECTION OF ENGINE START AND STOP OPERATION (RADIO
CONTROL)
Ensure that the boom and outriggers are all stowed in the correct positions.
If they are not in the correct positions, use the applicable levers on the machine side to
stow them correctly.
Otherwise, the transmitter operation may cause damage to the Crane or tipping that
results in serious injury.
[1] INSPECTION OF ENGINE START OPERATION
1. Turn “ON” the main starter switch on the machine
side.
2. Press the “start/stop radio control button” (3) of the
transmitter twice to turn the power “ON”.
3. Press the horn switch (7) and check that the horn
sounds.
4. Push down the “Engine start/stop switch (4)” to the
start side and check that the engine starts.
[2] INSPECTION OF ENGINE STOP OPERATION
1. After the engine has started as above [1], push
down the Engine start/stop switch (4) and check
that the engine stops.
2. After the engine has started as above [1], push the
Emergency stop switch (11) and check that the
engine stops.
Left side
Right side