203
3.8.5 OPERATION WHILE TRAVELLING WITH A SUSPENDED LOAD
Only in Travel mode does it become possible to change the
operation mode between Travel and Load carrying by
pressing the Load carrying/Fly jib change switch (7).
The mode can be changed in the same procedures as
those for hoisting/lowering the hook and for derricking the
boom.
For details, see “OPERATION 3.8.1 HOOK WINDING AND
UNWINDING", and “3.8.2 BOOM DERRICKING
OPERATION”.
• In case of any abnormality in crane operations,
immediately press the emergency stop switch or the
remote controller power ON/OFF switch (10) on the
transmitter to stop the engine. The abnormality
mentioned above includes: continuation of crane
operations even after the release of control levers,
or unexpected crane movements before the control
levers are used.
• In the event of an emergency stop of the engine,
investigate the cause for the abnormality and repair
the fault location.
• The emergency stop switch can also be used for
turning OFF the power to the remote control
transmitter or for stopping the engine.
3.8.6 FLY JIB DERRICKING/TELESCOPING OPERATION
Only in Crane mode, does it become possible to change
the operation mode between Boom and Fly jib by pressing
the Load carrying/Fly jib change switch (7).
The mode can be changed in the same procedures as
those for derricking/telescoping the boom.
For details, see “OPERATION 3.8.2 BOOM DERRICKING
OPERATION” and “OPERATION 3.8.3 BOOM
TELESCOPING OPERATION”.
To Next Page
Loading...
