Maeda MC815C - Machine Operation; Machine Stop and Checks after Stopping Machine

212
4.3 MACHINE OPERATION
CAUTION
After warm-up operation, before operating the crane, see from “OPERATION 2.5
MACHINE TRAVELLING POSTURE” to ”OPERATION 2.25 PROHIBITED OPERATIONS
DURING CRANE WORK”.
4.4 MACHINE STOP AND CHECKS AFTER STOPPING MACHINE
1. Turn the starter switch key to the “OFF” position.
The electric motor stops.
2. Remove the starter switch key.
3. Visually check for oil leakage, and check around the
crawlers, crane, and exterior of the machine. If you find
any leakage or abnormality, fix the problem.
4. Clean off the crawlers and outriggers, removing mud.
5. Keep the area around the inverter unit free of dead
leaves and paper waste. A potential fire could occur if
disregarded.