Maeda MC815C - Mounting Fly Jib

357
4.1 MOUNTING FLY JIB
Never perform any work riding on the crawler. You might slip and fall causing a serious
accident. To work in a high place, be sure to install a stable work table.
To mount a fly jib stowed in the right section of the main boom on the tip of the main boom, follow the
procedure below.
If the fly jib mounting bracket is already installed on the tip of the main boom, start from step 5.
1. Remove the fly jib mounting bracket (6) fixed with the eye
bolt (34) and washer (35) to the stowage bracket (33) at the
front of the vehicle.
NOTES
As the weight of the fly jib mounting bracket (6) is approximately
30 kg, hoist it using a crane.
2. Remove the nut (32), the plate (31) and the collar (29) and
pull out the head pin (28) completely so that the fly jib
mounting bracket (6) can be inserted.
NOTES
The head pin (28) does not need to be pulled out completely, as
long as the fly jib mounting bracket (6) can be attached.
The collar (29) will not be used, so please keep it and do not
lose it.
3. Attach the fly jib mounting bracket (6) and insert the point
pin (30) to fix it.
4. Put back the head pin (28) you have pulled out in step 2,
and fasten using the plate (31) and the nut (32).
NOTES
When mounting the fly jib mounting bracket (6), the collar (29)
removed in step 2 is not used.
5. Pull out the linchpin of the position pin (B1) of the stowage
bracket A (21) to pull out the position pin (B1).
Insert the position pin (B1) you have just pulled out into the
hole for storing a pin on the back of the fly jib bracket A (21).
After you insert it, lock securely with a linchpin.