5
This machine is composed of the following units and systems:
[1] CARRIER
The carrier consists of the travelling gear, engine, travelling operation unit, and crane operation
unit.
[2] CRANE
The crane consists of the telescopic boom, boom derricking system, slewing system, hook block,
winch system, and outrigger system.
[3] SAFETY DEVICE
This machine is equipped with the following safety devices: Over-hoist detector/automatic stop
system, excessive unwind detector, load indicator, hydraulic safety valve, hydraulic automatic
locking device, slinging rope detachment protector, alarm buzzer, leveling instrument, crane
tip-over alarm (issued if the machine tilts more than 3 degrees while being operated, or more
than 15 degrees while traveling), lock lever, travel/outrigger/crane selector switch (to prevent
crane from activated while traveling), outrigger safety device (outrigger interlock, crane
interlock), overload preventive device (with working envelope specified) and working status
lamp.
3.3 MACHINE FUNCTIONS
[1] CARRIER
• This machine is designed to have a compact overall width when the crane and outriggers are
stowed (traveling posture), which facilitates running in confined areas.
• Use of the two operation levers enables not only travel direction changes (forward, backward,
rightward and leftward) but also pivot turns and spin turns.
• By using the radio controller, it is possible to remotely control the movement of travel.
[2] CRANE
• This crane is equipped with automatic slide outriggers which enable the operator to extend and
set outriggers while seated on the driver's seat.
• Through the combination use of the telescopic boom, derricking and slewing systems besides
the winch system, the crane can raise and lower the hook block to move the lifted object to the
desired position within the rated total load and the specified working envelope.
• The outrigger setup and the crane operations can also be performed with the remote control
system.
To Next Page
Loading...
