Maeda MC815C - Maintenance Every 50 Hours

384
8.4 MAINTENANCE EVERY 50 HOURS
[1] Greasing
CAUTION
• Greasing a new machine is required once every 10 hours until the machine completes the first
100 hours of operation for the initial breaking-in period.
• If you hear any noise on the greasing point, grease immediately regardless of the inspection
and maintenance time.
Use proper grease specified below according to the greasing points.
No. Greasing point Grease type
1
Greasing hook block 2 places
Lithium grease
2
3 Greasing fly jib foot pin 1 place
4
No.2 fly jib, slide plate touching surface
Both
sides
Boom grease
5
Lower
side
6 No.1 fly jib, slide roller touching surface
Each
part
1. Grease the grease fittings using a grease pump.
2. Wipe off old grease squeezed out after greasing.
3. Use a brush or a roller to apply the boom grease.