395
4. MOUNTING AND STOWING SEARCHER HOOK
• We recommend mounting or stowing a searcher hook with two persons. They must fully
check the work content mutually and perform the operation based on the designated signals.
If the signals are insufficient, they may contact a moving part, which can cause a serious
accident.
• Mounting and stowing a searcher hook should be conducted on a stable work table with
sufficient height. If you use an unstable work table, a searcher hook can fall from a high place,
causing a serious accident.
• When mounting or stowing a searcher hook, make sure that the main boom is in a horizontal
position. Otherwise, a searcher hook can lose a balance and fall, causing a serious accident.
• The searcher hook is attached to the tip of the main boom with two position pins. Insert two
position pins in the correct positions and tighten them securely with a linchpin. If the position
pin comes off, the searcher hook may fall, causing a serious accident.
Never put your fingers into the pin hole.
• A searcher hook is attached and stowed to the left section of the main boom with two position
pins. Insert the position pins for fixing in the correct positions and tighten them securely with
linchpins. If the position pin comes off, the searcher hook may fall, causing a serious
accident.
• Be sure to change to the searcher hook mode on the monitor when the searcher hook is
mounted.
If you do not switch to the searcher hook mode, the moment limiter will not function properly,
causing a serious accident. Also, when you stow or remove the searcher hook, cancel the
searcher hook mode.
• When using with the hook block installed, make sure that the winch settings in searcher hook
mode is turned ON, on the monitor.
To Next Page
Loading...
