193
3.7.1 OUTRIGGER SETTING OPERATION
Before setting outriggers, read “OPERATION 2.14 OUTRIGGER SETTING OPERATION”
and also the precautions described there.
1. See “OPERATION 3.4 STARTING/STOPPING THE
ENGINE” to start the engine.
2. Change the mode to Extension with the Transmitter
speed selector/Outrigger select switch (6) on the
transmitter.
3. Operate the control levers to extend and set the
outriggers.
Repeat the above steps for the other two outriggers by
operating the mode selector switch (5).
Left lever: outrigger 1 or 2
Right lever: outrigger 4 or 3
To Next Page
Loading...
