197
4. Change the mode to Extension stowage with the Speed
selector/Outrigger select switch (6) for the transmitter.
5. When the grounding cylinder has been extended and
the adapter has been grounded by manipulating the
control lever, release your hand from the operation
lever.
Repeat this step to gradually lower the machine until
the crawler belts are completely grounded.
6. After the right and left crawler belts come to complete
contact with the ground, further operate the control
lever.
When the grounding cylinder has been completely
retracted and the top box is raised to the maximum
height, release your finger from the outrigger switch.
7. Make sure that the four outrigger grounding lamps (3)
on the outrigger indicator are blinking in red.
NOTES
On the monitor, the crane stowage lamp (1) is lit in yellow,
and the four outrigger extension lamps (2) and the four
outrigger grounding lamps (3) are blinking in red.
To Next Page
Loading...
