Maeda MC815C - Page 238

228
[3] STARTING ENGINE
Verify that the operation levers of both the slave machine and machine in failure are at
the “NEUTRAL” position. If the safety lock lever is equipped, also verify that it is at the
lock position.
1. Verify that the clips are securely connected to the battery terminals.
2. Start the engine of the slave machine and increase the engine speed to full speed (highest
speed).
3. Turn the starter switch of the failed machine to the “START” position to start the engine.
If the engine does not start, wait for more than 2 minutes before re-trying.
NOTES
See “OPERATION 2.2 STARTING ENGINE” for how to start the engine.
[4] DISCONNECTING BOOSTER CABLE
When the engine has started, disconnect the booster cable
in the reverse order of connecting the booster cable.
1. Disconnect the clip of the booster cable (B) connected
to the engine block of the machine in failure.
2. Disconnect the clip of the booster cable (B) connected
to the (-) terminal of the slave machine.
3. Disconnect the clip of the booster cable (A) connected
to the (+) terminal of the slave machine.
4. Disconnect the clip of the booster cable (A) connected
to the (+) terminal of the machine in failure.